Keyboard shortcuts

Press ← or → to navigate between chapters

Press S or / to search in the book

Press ? to show this help

Press Esc to hide this help

nRF52840 Dongle

The Nordic Semiconductor nRF52840 USB dongle, running the nRF Sniffer for 802.15.4 firmware, is used by the zigbee sniffer and zigbee capture plugins as a passive IEEE 802.15.4 receiver.

USB identifiers

All variants share vendor ID 0x1915 (Nordic Semiconductor ASA). iottack auto-detects the dongle by VID/PID via Linux sysfs. Use --port to override when multiple dongles are connected.

PIDMode
0x520FApplication (sniffer) mode
0xCA37DFU bootloader mode
0x154AnRF52 USB Product (generic)
0x154BnRF Sniffer for 802.15.4 official firmware

Flashing the firmware

Download the pre-built firmware package from the nRF Sniffer for 802.15.4 releases page and follow Nordic’s flashing guide. The dongle ships in bootloader mode (PID 0xCA37). After flashing it switches to application mode (PID 0x520F or 0x154B).

Linux setup

The dongle uses USB CDC-ACM and appears as /dev/ttyACM* without additional drivers. Grant unprivileged access by adding the user to the dialout group:

sudo usermod -aG dialout $USER

Log out and back in for the change to take effect. Alternatively, install a udev rule so any user can open the device:

echo 'SUBSYSTEM=="tty", ATTRS{idVendor}=="1915", MODE="0666"' \
  | sudo tee /etc/udev/rules.d/99-nrf52840.rules
sudo udevadm control --reload
sudo udevadm trigger

Plugins

PluginCommandPurpose
zigbee snifferiottack zigbee snifferPassive 802.15.4 frame capture with MAC-layer security analysis
zigbee captureiottack zigbee captureCapture raw 802.15.4 frames to a PCAP file for Wireshark