Keyboard shortcuts

Press ← or → to navigate between chapters

Press S or / to search in the book

Press ? to show this help

Press Esc to hide this help

I2C plugins

I2C (Inter-Integrated Circuit) is a two-wire serial bus widely used to connect sensors, EEPROMs, displays and other peripherals on embedded systems. A single bus master can address up to 112 devices using 7-bit addresses.

The protocol has no authentication or access control. Any device that can reach the bus can read sensor values, configuration registers, and stored data, and write to actuator outputs or configuration registers.

Hardware requirement

All I2C plugins require an FTDI MPSSE adapter (FT232H, FT2232H, or FT4232H) connected to the target bus. See FTDI adapter wiring for pin connections and the required udev rule.

Plugins

PluginCommandPurpose
scaniottack i2c scanProbe all 112 valid I2C addresses and report responding devices
readiottack i2c readRead bytes from a specific device register

Severity model

Discovered devices are reported at Medium severity. Their presence on the bus is the finding. Register reads are reported at Info since reading a known address and register is an intentional action rather than a discovery.